Question 1, True picture drawings are referred to as,
A) Perspective drawings.
Question 2, While installing a component, a dimension shown on a drawing as 10 mm (+/- 0.5 mm) means the dimension must be within,
B) 9.5 and 10.5 mm
Question 3, What does a solid line with a jog or freehand break in its length indicate?
D) A break line shortening an item by omitting part of a section.
Question 4, What is the maximum number of principal views available for use in an orthographic projection?
A) Three
Question 5, The thin solid lines with dimension lines in between are called,
A) Extension lines.
Question 6, Shop perspective drawings are similar to,
D) Isometric drawings.
Question 7, An engineering drawing can also be referred to as a,
C) Design drawing.
Question 8, HSS materials can be square, rectangular, or round. (True/False)
True
Question 9, When interpreting a bill of materials where a call out for C10 x 15.3 (250 x 23) is referenced, what is the size of this material?
C) 10 in (250 mm) flange to flange.
Question 10, What type of structural material does the designation W8 x 18 (W200 x 27) designate?
C) A wide flange beam.